AnsweredAssumed Answered

Lot sizes rule

Question asked by cornelius.talmidge on May 28, 2013
Latest reply on May 28, 2013 by cornelius.talmidge

I'm currently trying to write a rule that will allow me to create buildings based on lot sizes. If the lot is too big, split the building; if it is too small, reduce setbacks. At the moment i have randomised variations to make the buildings all different sizes. Except with smaller lots, I'm getting very thin buildings extruded. So I've added a case clause to try and sort this out, but to no avail.

Also, i can't seem to do multiple setbacks unless they're nested in each other within the Lot function. I would like the setbacks to be part of the case clause, but yet again...I'm struggling. Attached is my code.

Any help would be delightful.