Adjust color ramp raster tif

4251
14
Jump to solution
05-08-2017 03:51 AM
AnneTrampe
New Contributor

Hello everyone,

I am trying to reproduce the same characteristics of a raster tif than the same attached in the picture.

I have a raster tif with different value. I already excluded all values above 1000 as they are land area.

I now want to have a descrete color ramp or stretched color ramp, but want to adjust it with certain values/breaks where the colour changes. it should look like this:

But I just achieved this:

0 Kudos
1 Solution

Accepted Solutions
PanGIS
by
Occasional Contributor III

Start from the bottom.

Probably it's because the values overlap.

View solution in original post

14 Replies
PanGIS
by
Occasional Contributor III

Hi, not sure if it is what you need but you can give it a try:

change the stretch type into Min-Max

then check Edit High/Low value and change the values.

AnneTrampe
New Contributor

Now, I can set them manually, but I can not change the values in between. What I mean is: I want also a legend like above, showing the value steps between min and max with the values and like to adjust them manually so from 0.1-1, 1-10, 10-50, 50-100, 100-300 and 300-1000, but still as stretched color. Now it looks like this:

0 Kudos
PanGIS
by
Occasional Contributor III

Click on Labeling button and see change the values from there.

AbdullahAnter
Occasional Contributor III

I think there is same answered question , see this link Assigning static colors to specific values on a stretched color ramp  

AnneTrampe
New Contributor

Okay, I did the labelling. Changed number of intervals and as I don't want the same intervalls I tried to change the values manually, but didn' work. I type in the right value, but it switches back to the original value.

0 Kudos
PanGIS
by
Occasional Contributor III

Not sure why, but it does the same to me.

Do this:

1) labeling: change the values as you like

2) click OK to close the window (apparently I have to click twice)

3) straight after click Apply in the Symbology tab

4) reopen the Labeling and now it should be changed and the symbology reclassified.

AnneTrampe
New Contributor

Okay, now I can change the label, but still not the values. So in the end it is still wrong as I need to change the values that are in that class/range

0 Kudos
AnneTrampe
New Contributor

Value and Label should be the same

0 Kudos
PanGIS
by
Occasional Contributor III

Change the values, not the labels.

If you change the values, the labels change accordingly.

(Sorry, just realized that before I wrote "labels" instead of values.)

0 Kudos