Dense Matching Failed?

218
2
05-15-2018 11:14 AM
Labels (1)
Highlighted
New Contributor

Hi,

I'm a bit new to using this software but had patiently waited 5 days whilst it was procesing around 3000 images being careful not to disturb my laptop in this time to get the message below. Does this mean that none of the processing was completed or where do I go from here? I'm looking to create both a 2d and 3d map from the images. Any help very much appreciated!!

Reply
0 Kudos
2 Replies
Highlighted
New Contributor

I've had this happen when the block is too large to process and the D2M engine overloads the pc resources.  I hate to say it but 3,000 images may be suited for 2 projects/blocks.  I've had to do this on a few occasions and I run 2 K80 GPU's on a brand new 30k server.  So, its not uncommon to have to split the project.  

Reply
0 Kudos
Highlighted
New Contributor III

Might also try reducing point cloud densification settings, Dense: Image Scale and/or point density.

Reply
0 Kudos