Snapping of ArcGIS Online features fails in ArcGIS pro

4156
2
Jump to solution
09-01-2015 03:05 AM
HeidiLissner
New Contributor

Dear all, I'd like to edit a feature-layer that is published in ArcGIS Online with ArcGIS pro. I urgently require the snapping function. However, after enabling snapping I can only snap to the feature that is edited but not to other features of the layer. Does anyone has an idea how to solve this problem?

Thanks, Heidi

0 Kudos
1 Solution

Accepted Solutions
SeanJones
Esri Regular Contributor

Heidi,

Snapping to feature service layers is off by default. You can toggle this through the 'List by Snapping' view in the table of contents.

View solution in original post

0 Kudos
2 Replies
SeanJones
Esri Regular Contributor

Heidi,

Snapping to feature service layers is off by default. You can toggle this through the 'List by Snapping' view in the table of contents.

View solution in original post

0 Kudos
HeidiLissner
New Contributor

You are right! So far, I only enabled snapping in the toolbar. I wasn't aware of this additional “List by snapping” function in ArcGIS pro before. Thanks!

Von: Sean Jones

Gesendet: Mittwoch, 2. September 2015 18:52

An: Heidi Lißner

Betreff: Re: - Snapping of ArcGIS Online features fails in ArcGIS pro

GeoNet <https://community.esri.com/?et=watches.email.thread>

Snapping of ArcGIS Online features fails in ArcGIS pro

reply from Sean Jones<https://community.esri.com/people/sean_jones-esristaff?et=watches.email.thread> in ArcGIS Pro - View the full discussion<https://community.esri.com/message/548172?et=watches.email.thread#548172>

0 Kudos