Hec Geo-Ras- Problem with XS OID 0

AdamStonewall — Thu, 29 Jan 2015 18:06:15 GMT

Howdy,

I'm a GIS novice, so I apologize in advance if my question has an obvious answer. I looked around in the forums and saw somewhat similar discussions, but nothing that appeared to answer my question directly.

I'm attempting a revision to my older HEC-RAS model. I'm going through the steps of updating my centerlines, banks, xscutlines, etc. in HEC-Geo-Ras (version 10.1) in ArcMap (version 10.1). I did a test run of this in a very small area of my watershed, with successful results.

However, when I attempted to expand this to the entire watershed, I've run into a brick wall. Specifically, when I attempt the command XS CUTLINE ATTRIBUTES-> STATIONING, I receive the following error message:

"Problem with XS OID 0

-2147220990, The index passed was not within the valid range."

Any ideas on what could be tripping this process up? More specifically, do the terms "XS OID 0" and "-2147220990" have meaning to specific points in the watershed that area problems?

Thanks in advance,

Adam

Re: Hec Geo-Ras- Problem with XS OID 0

MattMead — Wed, 04 Mar 2015 17:04:13 GMT

Adam,

XS OID 0 is the cross section with OID(Object ID) of 0. If you open the XScutlines attribute table it should be easy to identify by finding the 0 value in the OID column. As for -2147220990, that I dont know what it is. Could you post a screenshot of your setup?

Some things you could check out in the meantime: Do you have any special characters in your Stream Name(ex. !, #, comas, periods, etc)? Is there just 1 stream centerline and does it touch the cross section only once? Does only 1 left, right and channel flowpath touch the cross section?

topic Hec Geo-Ras- Problem with XS OID 0 in Water Resources Questions

Hec Geo-Ras- Problem with XS OID 0

Re: Hec Geo-Ras- Problem with XS OID 0