topic Re: Fill Sinks crashing in Water Resources Questions

Fill Sinks crashing

Siri_JodhaKhalsa — Wed, 29 Jun 2016 19:38:00 GMT

I am using for the first time the deranged basin workflow in ArcHydro in ArcGIS 10.3. All goes well with the DEM preconditioning, I successfully defined sink polygons with larger ones set to IsSink =1. But when I execute Fill Sinks, it runs for a while but ultimately end with a (typically) undecipherable error message. Tried closing and reopening the proejct. Same result. Any suggestions besides upgrading to 10.4 (which I'm willing to do, just something I've been putting off)

Re: Fill Sinks crashing

DarrenWiens2 — Wed, 29 Jun 2016 20:15:18 GMT

Not that I don't believe you, but could you post the undecipherable error message (or is it like, "99999 Unspecified error"?)?

Re: Fill Sinks crashing

Siri_JodhaKhalsa — Wed, 29 Jun 2016 20:54:20 GMT

Hi Darren,

screen shots form my two attempts attached.

Re: Fill Sinks crashing

Siri_JodhaKhalsa — Wed, 29 Jun 2016 20:57:06 GMT

in case res too coarse to see text

Re: Fill Sinks crashing

DarrenWiens2 — Wed, 29 Jun 2016 21:05:40 GMT

You're right, that is undecipherable!

I don't have a real answer for you, but there are plenty of ideas here: ArcHydro Problem Solvers

Re: Fill Sinks crashing

Siri_JodhaKhalsa — Wed, 29 Jun 2016 21:32:28 GMT

I have executed many successful workflows with my current setup. It was only when I began creating sink polygons for a deranged basin that I ran into this problem. I think my setup is fine.

Re: Fill Sinks crashing

Siri_JodhaKhalsa — Thu, 30 Jun 2016 18:50:17 GMT

I've discovered that my SinkPoly grid is not recognized in the Data Management window as being a valid sink polygon (i.e. I can't assign that layer in the data management window).

I can fill sinks if I do not use the deranged polygon option (the layer that is somehow invalid) but then when I try to adjust flow direction with sinks I cannot select the sink polygon layer.

Any ideas?