topic Point Cloud Scene Layer not drawing in LIDAR Resources Questions

Point Cloud Scene Layer not drawing

JohnHuillery1 — Fri, 19 Jul 2019 13:43:17 GMT

I've created a Point Cloud Scene Layer using the Create Point Cloud Scene Layer Package geoprocessing too and it will not draw in ArcGIS Pro. The point cloud will flash for half a second then disappear.

The las file used to create the Point Cloud Scene Layer Package is a photogrammetric RGB point cloud created in Pix4D.

Re: Point Cloud Scene Layer not drawing

Andrew--Johnson — Fri, 19 Jul 2019 15:30:01 GMT

Hi,

Can you answer some of these questions to help narrow down the issue?

What coordinate system is the slpk in?

Have you tried adding to both a global and local scene?

Have you tried turning off the elevation source to ensure it is not blocking the data?

Have you tried adjusting the display limit to say 9,000,000?

Thanks!

-Andrew

Re: Point Cloud Scene Layer not drawing

JohnHuillery1 — Fri, 19 Jul 2019 16:47:24 GMT

Hello,

CRS info (see below):

I've tried everything else that you had suggested, still not displaying anything.

Thanks,

John

Re: Point Cloud Scene Layer not drawing

Andrew--Johnson — Fri, 19 Jul 2019 16:57:09 GMT

Hi John,

Are you able to provide the las file so we can take a look on our end? If so, please provide your email and I can send you a FTP link.

thanks,

Andrew

Re: Point Cloud Scene Layer not drawing

JohnHuillery1 — Fri, 19 Jul 2019 17:30:34 GMT

Any way I can private message you that?

Re: Point Cloud Scene Layer not drawing

Andrew--Johnson — Tue, 06 Aug 2019 22:21:20 GMT

To close the loop on this:

The issue is specific to the automatic view clipping mode. To get around this set it to Manual mode

1) Click on View Tab

2) In the View Clipping Group click the mode dropdown and select Manual

Re: Point Cloud Scene Layer not drawing

JordanJSimpson — Thu, 07 Jul 2022 12:42:58 GMT

I've also created a Point Cloud Scene Layer and it is not drawing, although I do not have the option to select mode dropdown in the view clipping group.

I've tried the steps described above and they aren't helping either,

Do you have any suggestions?

Thanks

Jordan