topic Re: Adding data inside of model builder in Geoprocessing Questions

Adding data inside of model builder

MeredithGreen — Fri, 03 Jan 2014 13:23:14 GMT

I am building a model that fills out a table just like what is depicted in the jpeg file attached. However, I need to add Summaries like what is highlighted at the bottom and sum everything up from above. I am not sure how to do this in model builder as I have never done it before. Is there a way? Any help would be greatly appreciated.

Thanks,

[ATTACH=CONFIG]30213[/ATTACH]

Re: Adding data inside of model builder

JakeSkinner — Fri, 03 Jan 2014 13:57:14 GMT

Hi Meredith,

You can run the Summary Statistics tool and then Append the results to the original table.

Re: Adding data inside of model builder

JasonJordan1 — Fri, 03 Jan 2014 14:11:22 GMT

Hey Meredith,
I've just started recently using model builder so this may be the most inefficient way to go about it. What about a combination of the spatial summary tool and the add join tool? so you run the spatial summary tool. It creates an output table, you then join that table back to your original table. Or maybe an Append (data management) tool instead of a join. Just append you summary output back to your desired target dataset.

Hope this helps and if not, eliminates some possible answers

cheers,
Jason