Struggling with a projection issue in Arcpad 10.22

JohnSchutt — Wed, 01 Nov 2017 01:40:00 GMT

Hello,

I am struggling with a projection issue in Arcpad 10.22. In ArcMap I created a shapefile layer of points by digitizing. I then opened arcpad and in a new map added the point layer rather than use ArcPad data Manager. View the two attached screen captures and you can see the huge discrepancy in the Lat/Longs from ArcMap to ArcPad in the Status Bar. Can’t figure why Arcpad shows 377,683+ degrees North when ArcMap correctly shows 86+ degrees South. Am using WGS 1984 Antarctic Polar Stereographic projection. Thanks in advance for any insights

John

Re: Struggling with a projection issue in Arcpad 10.22

MarikaVertzonis — Wed, 01 Nov 2017 04:29:18 GMT

The steps you describe sound correct (creating in ArcMap, add to a new map in ArcPad, they should appear the same), so i wonder if the projection that your expecting is in fact being used in ArcPad. To check:

1. Select the layer in the Table of Contents

2. Choose Map Properties

3. Go to the projection tab

Do you see the expected projection listed in the Projection page?

topic Re: Struggling with a projection issue in Arcpad 10.22 in ArcPad Questions

Struggling with a projection issue in Arcpad 10.22

Re: Struggling with a projection issue in Arcpad 10.22