topic Setting Tolerance in ArcEngine10 Edit mode in ArcObjects SDK Questions https://community.esri.com/t5/arcobjects-sdk-questions/setting-tolerance-in-arcengine10-edit-mode/m-p/333555#M8693 <HTML><HEAD></HEAD><BODY><SPAN>I have an application on a touch enabled device in which I'm using ArcEngine 10 to run the map control. I'm using the toolbar control to start the engine editor to edit map features. When I start the editor, I notice that the tolerance is this tiny dot and the features on the map are very difficult to select and move using a finger. </SPAN><BR /><BR /><SPAN> My question is, how do I increase the tolerance level on the features on the map during that edit session? Is that controlled in the MXD, or is it some code that I need to add to the initialization of the map control? Any assistance on this would be greatly appreciated.</SPAN><BR /><BR /><SPAN> Howard</SPAN></BODY></HTML> Mon, 17 Jun 2013 10:58:30 GMT HowardNaulty 2013-06-17T10:58:30Z Setting Tolerance in ArcEngine10 Edit mode https://community.esri.com/t5/arcobjects-sdk-questions/setting-tolerance-in-arcengine10-edit-mode/m-p/333555#M8693 <HTML><HEAD></HEAD><BODY><SPAN>I have an application on a touch enabled device in which I'm using ArcEngine 10 to run the map control. I'm using the toolbar control to start the engine editor to edit map features. When I start the editor, I notice that the tolerance is this tiny dot and the features on the map are very difficult to select and move using a finger. </SPAN><BR /><BR /><SPAN> My question is, how do I increase the tolerance level on the features on the map during that edit session? Is that controlled in the MXD, or is it some code that I need to add to the initialization of the map control? Any assistance on this would be greatly appreciated.</SPAN><BR /><BR /><SPAN> Howard</SPAN></BODY></HTML> Mon, 17 Jun 2013 10:58:30 GMT https://community.esri.com/t5/arcobjects-sdk-questions/setting-tolerance-in-arcengine10-edit-mode/m-p/333555#M8693 HowardNaulty 2013-06-17T10:58:30Z