https://community.esri.com/t5/arcmap-questions/visualizing-and-analyzing-smaller-contours-on/m-p/1018358#M1899 <P>I have been generating kriging layers which contain small regions of detail that are not appearing at certain levels of zoom. Areas which appear as a flat signal actually have a small pocket of increased material in a certain location, but this detail will only appear with the "Refine on Zoom" visualization option turned on (i.e. invisible at 1:80,000, visible at 1:60,000). Questions:</P><P>Q1. Is it possible to adjust ArcMap so that it will draw these finer detail from a further out viewing window? I don't mind if the details are small.</P><P>Q2. After kriging, I convert the layer to a contour file for downstream analyses (i.e. intersection). However, when I do "GA Layer to Contour", the smaller detail I refer to above is ignored (not present in the generated shape file), even if I perform this conversion while I have zoomed in on the layer file so that the small details are visible. Is there an option that will allow for these finer details to appear in this conversion?</P><P>Thank you.</P> Wed, 20 Jan 2021 16:03:32 GMT EliseosMucaki 2021-01-20T16:03:32Z https://community.esri.com/t5/arcmap-questions/visualizing-and-analyzing-smaller-contours-on/m-p/1018358#M1899 <P>I have been generating kriging layers which contain small regions of detail that are not appearing at certain levels of zoom. Areas which appear as a flat signal actually have a small pocket of increased material in a certain location, but this detail will only appear with the "Refine on Zoom" visualization option turned on (i.e. invisible at 1:80,000, visible at 1:60,000). Questions:</P><P>Q1. Is it possible to adjust ArcMap so that it will draw these finer detail from a further out viewing window? I don't mind if the details are small.</P><P>Q2. After kriging, I convert the layer to a contour file for downstream analyses (i.e. intersection). However, when I do "GA Layer to Contour", the smaller detail I refer to above is ignored (not present in the generated shape file), even if I perform this conversion while I have zoomed in on the layer file so that the small details are visible. Is there an option that will allow for these finer details to appear in this conversion?</P><P>Thank you.</P> Wed, 20 Jan 2021 16:03:32 GMT https://community.esri.com/t5/arcmap-questions/visualizing-and-analyzing-smaller-contours-on/m-p/1018358#M1899 EliseosMucaki 2021-01-20T16:03:32Z