topic Re: Run Web AppBuilder for Developers under HTTP in ArcGIS Web AppBuilder Questions

Run Web AppBuilder for Developers under HTTP

ZdeněkSoldán — Fri, 17 Jun 2016 09:13:04 GMT

Hello,

I installed Web AppBuilder for Developers on our geoportal. When I run starup.bat Web AppBuilder always start under https even if I rewrite url adress to http it switch to https again. I have a web map where services are loaded under HTTP and when I want to add this web map to web appbuilder in developer tools I see erros with mixed content: Mixed Content: The page was loaded over HTTPS, but requested an insecure XMLHttpRequest endpoint This request has been blocked; the content must be served over HTTPS.

Is there any possibility how to run web AppBuilder under http? Or any other solutions to this problem?

Thanks for any help.

Re: Run Web AppBuilder for Developers under HTTP

RobertScheitlin__GISP — Fri, 17 Jun 2016 10:47:59 GMT

Zdendek, When you mention Geoportal do you mean you have Portal on premise? If so then Portal is only run using HTTPS and your rule that you are registering is using https so the WAB dev will always be in https. If you did not mean you have on premise Portal, then make sure you delete the signininfo.json and make sure to use an http address when specifying your portal rule and go back to the registering the app sets and make sure you do not use any https address for your re-directs.

Re: Run Web AppBuilder for Developers under HTTP

ZdeněkSoldán — Fri, 17 Jun 2016 11:08:30 GMT

Hello Robert,

Yes I meat Portal. So is any possibility how to use web maps with http connections in WAB registred on Portal?

Re: Run Web AppBuilder for Developers under HTTP

RobertScheitlin__GISP — Fri, 17 Jun 2016 11:19:02 GMT

Not that I am aware of.

Re: Run Web AppBuilder for Developers under HTTP

ZdeněkSoldán — Fri, 17 Jun 2016 11:21:04 GMT

Ok,

Thank you for your answers