topic Re: Apply Asset Package FAILED TO EXECUTE in ArcGIS Utility Network Questions

Apply Asset Package FAILED TO EXECUTE

Vikranth_Madeppa — Thu, 22 May 2025 16:10:59 GMT

I am trying to Apply asset package and I keep getting this error. Have tried multiple times now. Any insights on this would be much appreciated.

Thanks & Regards

Re: Apply Asset Package FAILED TO EXECUTE

MikeMillerGIS — Thu, 22 May 2025 17:59:14 GMT

What are your parameters? What is your target GDB type? Have you tried Asset Package to Geodatabase?

Re: Apply Asset Package FAILED TO EXECUTE

Vikranth_Madeppa — Thu, 22 May 2025 18:37:54 GMT

Hi Mike,

I have not tried asset package to GDB . Can you explain further how I can use this and apply to Utility network ?

Thanks & Regards,

Re: Apply Asset Package FAILED TO EXECUTE

Vikranth_Madeppa — Thu, 22 May 2025 18:41:06 GMT

I am doing this process in a FIle GDB , created a UN in file GDB and using Apply asset package to this UN.

I am always getting this Domain Network error.

Is there a way to check the difference in the domains of my asset package and UN, so that I can find out what the issue is and fix it ?

Re: Apply Asset Package FAILED TO EXECUTE

MikeMillerGIS — Thu, 22 May 2025 18:54:12 GMT

Try Asset Package to Geodatabase, it creates a new geodatabase, stages the UN and then applies the asset package. This will eliminate some variables.

Re: Apply Asset Package FAILED TO EXECUTE

Vikranth_Madeppa — Thu, 22 May 2025 19:15:26 GMT

Thank you very much .

Asset Package to Geodatabase worked. But I did get some error.

Its an error for subtypes (Structure Boundary , Water Line, WaterDevice_1_Fields-Subtypes-CV.xml:1195)

Just trying to figure out the subtype fields and the difference in schema.

Re: Apply Asset Package FAILED TO EXECUTE

MikeMillerGIS — Thu, 22 May 2025 19:38:52 GMT

I would try this
Start a brand new ArcGIS Pro sessions

Do not add any maps

Run the Asset Package to Geodatabase

Re: Apply Asset Package FAILED TO EXECUTE

JoaquinMadrid1 — Fri, 23 May 2025 15:54:50 GMT

Mike's recommendation to run AP2GDB before going through the whole Apply to EGDB is the way to go. We have it as part of our standard process. You catch a lot of stuff running AP2GDB without "polluting" the E-GDB. And then you easily clean up the AP and try again.

This minimal overhead saves a lot of time and headaches. Thank you, Mike,.