topic isolation tracing not show domain code at travesability in ArcGIS Utility Network Questions

isolation tracing not show domain code at travesability

NadiaAlami — Mon, 04 Mar 2024 04:37:20 GMT

Hi everyone, we try to run isolation tracing, however when to choose the value, the code domain not available as shown below, i need to key in the code.

But, for lifecycle status, the domain shown

we already set the domain when create the network attribute

What should we do..

thank you..

Re: isolation tracing not show domain code at travesability

MikeMillerGIS — Mon, 04 Mar 2024 11:17:51 GMT

Sadly, it does not use the domain of the inline network attribute. It uses the domain assigned at the field of the first class that NA is assigned to.

Re: isolation tracing not show domain code at travesability

RobertKrisher — Mon, 04 Mar 2024 14:32:01 GMT

@NadiaAlami Make sure that your device class has the correct domain assigned to it at the object class level (for this UI), and that each subtype/asset group that corresponds to an operable device has this domain assigned at the subtype level (for the attribute editor).

Re: isolation tracing not show domain code at travesability

NadiaAlami — Sun, 10 Mar 2024 04:20:09 GMT

Hi MikeMillerGIS, thank you so much, i understand and manage to solve it.

Re: isolation tracing not show domain code at travesability

NadiaAlami — Sun, 10 Mar 2024 04:22:49 GMT

Hi RobertKrisher.
Yes i assign the domain and manage to solve the problem.
Thank you so much for your help.