topic Re: Select by location source layer not enabled in ArcGIS Pro Questions https://community.esri.com/t5/arcgis-pro-questions/select-by-location-source-layer-not-enabled/m-p/209115#M9299 <HTML><HEAD></HEAD><BODY><P>OK, I found the solution in case it helps someone else.</P><P></P><P>What I thought was a polygon was actually a closed group of lines</P><P></P><P>I should have known because it didn't show as a filled object on the screen.</P><P></P><P>"Features To Polygon" closed it, filled it, and allowed it to be used with a "Select By Location" quest.</P><P></P><P>The "Use Selected Features" is still gray, so that had nothing to do with the problem</P></BODY></HTML> Mon, 23 Dec 2019 11:31:07 GMT HankArnold 2019-12-23T11:31:07Z Select by location source layer not enabled https://community.esri.com/t5/arcgis-pro-questions/select-by-location-source-layer-not-enabled/m-p/209114#M9298 <HTML><HEAD></HEAD><BODY><P>I have a polygon created using "Points To Line" and a large array of points extracted from a raster. Both the polygon and the point array have the same coordinate system and display properly.</P><P></P><P>I also have a RELATE between the two defined.</P><P></P><P>When I go to so a "Select By Location", the source layer pulldown allows me to select the polygon, but the "Use Selected Features" box is grayed out and it says "0 Features Selected"</P><P></P><P>See attached.</P><P></P><P>It allows me to run a selection, and the spinning wheel runs for a while, but no records in the point array are selected.</P><P></P><P>I've tried defining the polygon by KML conversion and the same thing happens</P><P></P><P>Suggestions?</P><P></P><P>Thanks in advance.</P></BODY></HTML> Sun, 22 Dec 2019 22:01:20 GMT https://community.esri.com/t5/arcgis-pro-questions/select-by-location-source-layer-not-enabled/m-p/209114#M9298 HankArnold 2019-12-22T22:01:20Z Re: Select by location source layer not enabled https://community.esri.com/t5/arcgis-pro-questions/select-by-location-source-layer-not-enabled/m-p/209115#M9299 <HTML><HEAD></HEAD><BODY><P>OK, I found the solution in case it helps someone else.</P><P></P><P>What I thought was a polygon was actually a closed group of lines</P><P></P><P>I should have known because it didn't show as a filled object on the screen.</P><P></P><P>"Features To Polygon" closed it, filled it, and allowed it to be used with a "Select By Location" quest.</P><P></P><P>The "Use Selected Features" is still gray, so that had nothing to do with the problem</P></BODY></HTML> Mon, 23 Dec 2019 11:31:07 GMT https://community.esri.com/t5/arcgis-pro-questions/select-by-location-source-layer-not-enabled/m-p/209115#M9299 HankArnold 2019-12-23T11:31:07Z