https://community.esri.com/t5/arcgis-pro-questions/create-feature-direction-in-radian-not-degree/m-p/1144554#M51543 <P>Ok, I found where to change it - didn't realise you can and have to change the format of the Direction under options - it was set to a wrong format and changing it to decimal degrees solved the issue.</P> Wed, 16 Feb 2022 11:15:30 GMT IlkaIllers1 2022-02-16T11:15:30Z https://community.esri.com/t5/arcgis-pro-questions/create-feature-direction-in-radian-not-degree/m-p/1144553#M51542 <P>I have to create polygons at specific angles. However, I realised (by creating a square that should be 90° aligned to N) that the numbers are probably radians? Inputting 90 results in a "wonky" square. Inputting a 100 it goes straight east, inputting 200 it goes straight south.&nbsp;</P><P>I went to the options and under Units it is set to Degree, and under Directions to North Azimuth. What else needs changing so I can use degrees here? My CRS is a UTM. Couldn't find any other settings to change this.</P> Wed, 16 Feb 2022 11:11:46 GMT https://community.esri.com/t5/arcgis-pro-questions/create-feature-direction-in-radian-not-degree/m-p/1144553#M51542 IlkaIllers1 2022-02-16T11:11:46Z https://community.esri.com/t5/arcgis-pro-questions/create-feature-direction-in-radian-not-degree/m-p/1144554#M51543 <P>Ok, I found where to change it - didn't realise you can and have to change the format of the Direction under options - it was set to a wrong format and changing it to decimal degrees solved the issue.</P> Wed, 16 Feb 2022 11:15:30 GMT https://community.esri.com/t5/arcgis-pro-questions/create-feature-direction-in-radian-not-degree/m-p/1144554#M51543 IlkaIllers1 2022-02-16T11:15:30Z