https://community.esri.com/t5/arcgis-javascript-maps-sdk-questions/featurelayer-a-single-point-label-disappears/m-p/1216963#M78858 <P>I have a FeatureLayer of points which is dynamically created from json (pulled from a database). When labels are switched on there is just a single point which misbehaves when zooming past a certain level. The label will display at smaller scales if I switch off smart labelling (<SPAN>deconflictionStrategy</SPAN><SPAN>:</SPAN> <SPAN>'none'), but then disappears and doesn't reappear after zooming past a certain level. All the other points behave normally. It is nothing to do with scales, whether I set a maxScale or minScale or no scales at all and I have also tried different label placements. If I change the Y coordinate of the point by the 5th or 6th decimal point (i.e. sub-meter - gps points in DD) then the point label will behave and show at all levels.</SPAN></P><P>I have also tried isolating the point so there are no others in the layer but the label still disappears. This is an edge-case issue as hundreds of these layers are viewed everyday but it has only been spotted by users a handful of times.</P><P><SPAN>I am using 4.23 but have also tried 4.24 but to no avail.</SPAN></P><P><SPAN>Any suggestions appreciated</SPAN></P> Wed, 28 Sep 2022 15:05:33 GMT DaveAdams 2022-09-28T15:05:33Z https://community.esri.com/t5/arcgis-javascript-maps-sdk-questions/featurelayer-a-single-point-label-disappears/m-p/1216963#M78858 <P>I have a FeatureLayer of points which is dynamically created from json (pulled from a database). When labels are switched on there is just a single point which misbehaves when zooming past a certain level. The label will display at smaller scales if I switch off smart labelling (<SPAN>deconflictionStrategy</SPAN><SPAN>:</SPAN> <SPAN>'none'), but then disappears and doesn't reappear after zooming past a certain level. All the other points behave normally. It is nothing to do with scales, whether I set a maxScale or minScale or no scales at all and I have also tried different label placements. If I change the Y coordinate of the point by the 5th or 6th decimal point (i.e. sub-meter - gps points in DD) then the point label will behave and show at all levels.</SPAN></P><P>I have also tried isolating the point so there are no others in the layer but the label still disappears. This is an edge-case issue as hundreds of these layers are viewed everyday but it has only been spotted by users a handful of times.</P><P><SPAN>I am using 4.23 but have also tried 4.24 but to no avail.</SPAN></P><P><SPAN>Any suggestions appreciated</SPAN></P> Wed, 28 Sep 2022 15:05:33 GMT https://community.esri.com/t5/arcgis-javascript-maps-sdk-questions/featurelayer-a-single-point-label-disappears/m-p/1216963#M78858 DaveAdams 2022-09-28T15:05:33Z