POST
|
I'm afraid of arc top is a problems which must be solved. Any more, How to make a flat ceiling tunnel in CityEngine.
... View more
07-22-2012
11:11 PM
|
0
|
0
|
565
|
POST
|
Hi, The pic is a ArcMap screenshot; I use more than 30 points test,and the maximum deviation nearly 50 centimeters(the width in that direction is 5 meters); The export format is GDB file; at last ,all my data is geolocated.
... View more
07-12-2012
10:42 PM
|
0
|
0
|
236
|
POST
|
Hi, Yes,This is a CityEngine screenshot.The main CGA as below: Tunnel--> extrude(world.y,10) center(xz) comp(f){world.up:Tunnel_tex} Tunnel_tex--> extrude(world.y,10) alignScopeToGeometry(yUp, 0,2) i(SuiDao_modPath) // replace by obj file and the sloped tunnels is needed.Any good way to slove this problem?
... View more
07-12-2012
10:23 PM
|
0
|
0
|
565
|
POST
|
hi, When i make a tunnel with i() rule, found that between two paragraphs will crack.Any good way to make a tunnel in CityEngine? [ATTACH=CONFIG]15903[/ATTACH]
... View more
07-09-2012
07:06 PM
|
0
|
5
|
2566
|
POST
|
Hi, I made some building blocks from points, then use center() rule to make sure the building???s center is the point ,but when the model imported into the ArcMap, found that the point is not in the center of the model.Of course, not all points are not in the center of the model. [ATTACH=CONFIG]15898[/ATTACH] Ladder--> s(5,50,10) r(0,-162,0) center(xz) i("builtin:cube") It is my rules ,and the picture shows the ploblem.I want to know the cause of the problem?
... View more
07-09-2012
06:06 PM
|
0
|
5
|
591
|
Online Status |
Offline
|
Date Last Visited |
11-11-2020
02:23 AM
|