POST
|
Hi Kevin, Thanks for the information; I thought this might be the case. I shall try and modify the model to utilise the Join Field Tool instead of the Add Join/Calculate Field/Remove Join process. Thanks again Paul
... View more
12-10-2013
05:51 AM
|
0
|
1
|
368
|
POST
|
Hello, Can anyone help!? I have a reasonably complex Model and want to Geoprocess in the background; however the "Always run in foreground" option is checked and greyed out. The reason for this is that I have the 'Remove Join' System Tool in my Model and in the Joins Toolset the Remove Join Tool also has the "Always run in foreground" option checked and greyed out so is passing this onto the Model. Is there any way to un-grey and uncheck this option in System Tools? This is a change in 10.1 as the Remove Join Tool does not have the "Always run in foreground" option checked in 10.0. Thanks in advance to anyone who can help Regards Paul
... View more
12-10-2013
01:01 AM
|
0
|
3
|
2121
|
POST
|
Hi mamcgirr I have a fair few near processes in my model with a lot of point to line near analysis. The way I made it work was to densify the lines so that there was a vertex every 1 m (this was accurate enough for my application), I converted the vertices to points and subsequently ran the near analysis on the two point feature classes. The model runs through no problem now with the point to point near analysis. You could try converting your feature classes to points if possible, it worked for me. Paul
... View more
11-19-2012
07:52 AM
|
0
|
0
|
267
|
POST
|
Hello, I have produced rather a large model in Arc10, service pack 4. I have a few Near Tool processes within the model. When I run the model as a whole it will hang on a couple of these Near Processes and just won't carry on, or takes ages and write the information as -1 only! If I have the model open in edit mode and cancel the process when it starts to hang, I can carry on where it stopped and the near analysis works fine, so there is nothing wrong with any of the inputs etc. I just need to be able to run the whole Model in one go without this hanging problem, anyone have any ideas? Thanks and Regards Paul
... View more
11-01-2012
06:56 AM
|
0
|
4
|
2885
|
POST
|
Hello, I have produced rather a large model in Arc10, service pack 4. I have a few Near Tool processes within the model. When I run the model as a whole it will hang on a couple of these Near Processes and just won't carry on, or takes ages and write the information as -1 only! If I have the model open in edit mode and cancel the process when it starts to hang, I can carry on where it stopped and the near analysis works fine, so there is nothing wrong with any of the inputs etc. I just need to be able to run the whole Model in one go without this hanging problem, anyone have any ideas? Thanks and Regards Paul
... View more
11-01-2012
06:52 AM
|
0
|
1
|
780
|
Online Status |
Offline
|
Date Last Visited |
11-11-2020
02:24 AM
|