POST
|
Thanks, Jay. The larger states work now I've set the value at 1. However, I'm still having the same problem when trying to run at a national level, for which there are over 2,500 facilities. Is the program simply not meant to handle a request that large?
... View more
04-12-2012
05:15 AM
|
0
|
0
|
435
|
POST
|
Robert, Thanks for the input. While I actually didn't know the details you just explained, I did still have chunking turned on when I ran the analysis with the Overlap option.
... View more
04-04-2012
11:45 AM
|
0
|
0
|
435
|
POST
|
Tried running with the overlap option and got the same result. After about 80 minutes of runtime, the status bar jumped from "solve 22% Complete" to being done, with no polygons generated. Is this still a memory issue, or is the program just timing out some reason midway through the process?
... View more
04-04-2012
06:46 AM
|
0
|
0
|
435
|
POST
|
Using 10.0 and my computer has 4.0 GB RAM. I'm using the 15, 30, and 60 minute intervals for a TRAVEL_TO analysis. There are ~150 facilities (using CA hospitals). For polygon generation I'm using Simple_Polys; Merge; Disks; and Trim Polygons. Here are the settings/values I put in using regedit: Service Area EdgeChunk- 100000 ForceChunking- 1 PolygonChunkSize- 5
... View more
04-03-2012
11:42 AM
|
0
|
0
|
435
|
POST
|
I am creating state-by-state service area analyses for 15, 30, and 60 min drive times to facilities. I've had no problems solving the smaller states, but when I try to do CA, TX, etc., no polygons are generated after running Solve (even though I'll get the green check saying it ran successfully). No error messages either. I've already gone into regedit and edited the DWORD values in case it was a memory issue, but no change in the outcome. Any ideas would be greatly appreciated.
... View more
04-03-2012
10:25 AM
|
0
|
8
|
1985
|
Online Status |
Offline
|
Date Last Visited |
11-11-2020
02:23 AM
|