Latest Contributions by deleted-user-iwYtitJHBIyn

Hello, I have just started experimenting with Operations Dashboard and really enjoy the interface. I have a question regarding data display spanning multiple layers. For example: I have three layers (1 polygon and 2 points); one layer features 4 different polygons - call them "Boundary Areas A - D", another consists of a small number of point locations - call them "Sites", and the last one consists of a larger number of point locations - call them "Address Points".  All point locations, with varying numbers, can be found within each of these polygon areas. At present, I have set-up 2 summary widgets per each of the Boundary Areas.  For instance, Boundary Area A has a count for the Sites in one widget and a count for the Address Points in another widget and so on through Boundary D. I would like to have another widget displaying the result of a mathematical operation between each of these two windows...for instance...say there were 5 Sites and 200 Address Points for Boundary A...the operation would be the following...5/200 x 100 and the widget would display 2.5%. Is it possible to perform such a calculation given that the calculated response spans two separate layers instead of all the information being contained within one layer? Thank you. Jeff ... View more

Hello, I have added and configured the Directions Widget for a web application. Unfortunately, it is not maintaining my preset start point location. The geocoder recognizes the address and I select it from the drop down but when I initialize the widget upon launch the #1 slot is empty. Any suggestions? Thank you. Jeff ... View more

Hello, I need to find an easy way to update multiple values in a file geodatabase attribute table.  These same values will need to be found in the table and replaced with values that I have within a list on a monthly basis so I would very much like to make this an automated function. Is this possible? My abilities are not quite there yet when it comes to programming so any assistance or guidance someone can provide would be extremely valuable. Thank you in advance. Jeff ... View more

Hello, An issue has popped up when using our Print function within AGO.  At least I think it is connected to the print function. One of our custom widgets is for Mailing Notifications.  We've noticed that if the mailing notifications (parcels) highlighted on the screen exceed around 300 or so and we would like to print the screen depiction we receive an error message saying "Error, try again" and "not enough storage to complete this operation" for one, or another message indicating an issue communicating with the print service. If we stay around 200 or less, there are no error messages and the graphic prints fine. I was wondering if there is anything in the service that I need to adjust? Thanks. Jeff ... View more

Hello Everyone, I've recently added the Directions Widget to an application I've assembled for my building inspection staff.  The widget will handle most of my staff's needs, however, I did get a question during our pre-roll-out session concerning one aspect.  I have not been able to find any previous communications or postings so I thought I would send out a general inquiry to the group. Is there a way to modify this widget, or for that matter has an enhanced widget been created, with the ability to group stops by AM and PM?  In this way, the inspectors would really have two complete route sets, one for AM visits and another for PM visits on the same map with the accompanying directions information segregated by time frames.  With ArcGIS Desktop Network Analyst you can create time windows that are "sort of" what I am referring to in this question but I don't think the modification needs to be that extensive. Thank you. Jeff in GeoNet HelpLike Show 0 Likes (0) • Comment • Share ... View more