Latest Contributions by BubbaHey

I've seen this when the accounts don't match up. Have you tried running Configure ArcGIS Server Account? ... View more

9.1 is no longer supported, so no surprise you might get errors. I understand some organizations can't for various reasons, upgrade, but it is recommended. ... View more

I would go to the web adaptor config page and configure it again. If still a problem, uninstall/reinstall. ... View more

What operating system?  Check Firewall - and make sure ports are open, especially port 6080 See: Ports used by ArcGIS Server ArcGIS Help (10.2, 10.2.1, and 10.2.2)‌ ... View more

I had problems upgrading web adaptor. I would try uninstalling web adaptor, then installing 10.2.2 - clean install, no upgrade. Maybe even deleting the arcgis folder if it remains, then install ... View more

I've seen it but can't remember resolution. From the Help: If you encounter a failure when creating or joining an ArcGIS Server site, you can troubleshoot the issue by addressing the error messages reported in the create site or join site summary panel. Additionally, a log of the event is recorded on disk, located at <ArcGIS for Server installation directory>\ArcGIS\Server\usr\logs\<machine name>\server. The messages in the log can provide additional insight into what caused the issue. To view the log, navigate to the logs directory and open the log in a text editor. Maybe the logs will give a clue ... View more

Look at this article:    Error:  Application Error: Access to the path �??C:\Inetpub\wwwroot\arcgis\WebAdaptor.config�?? is denied http://support.esri.com/en/knowledgebase/techarticles/detail/40406 You may also have to change Identity in the ArcGISWebAdaptorAppPool ... View more

Correct me if I'm wrong, but I'm not aware of any Trial versions of Server.  You could call Customer Service and ask, depending on who you get, some of them are very helpful in giving out trial versions of products ... View more

What a lot of people do is use a CA certificate in IIS for web adaptor, then a self-signed in ArcGIS Server. Mainly because server seems to have problems importing CA certificates. See: http://resources.arcgis.com/en/help/main/10.1/index.html#/Enabling_SSL_on_ArcGIS_Server_when_accessed_through_the_ArcGIS_Web_Adaptor/015400000600000000/ ... View more

It depends on what ArcGIS server you configure the web adaptor to.  If arcgis1 and arcgis2 point to same GIS server, and the GIS server goes down, you're dead in the water.  There's not a lot of info on load balancing. Here's one link: http://resources.arcgis.com/en/help/main/10.2/index.html#/Deployment_scenarios/015400000488000000/ ... View more

Try the following: 1. remove all bindings 2. add binding, for example,  port http port 80 3. leave host name blank 4. reinstall web adaptor ... View more

Not sure on this one, but see: The ArcGIS Server account http://resources.arcgis.com/en/help/main/10.2/index.html#//0154000004w1000000 ... View more

See: Resetting a forgotten password http://resources.arcgis.com/en/help/main/10.2/index.html#//0154000005pw000000 ... View more

Thanks, good info.  I had problems installing on 2012 because of .net 3.5.1, can't remember how I got it going ... View more

I've seen the upgrade fail sometimes. Are you able to uninstall 10.2, then install 10.2.2? ... View more