Just working on creating OIS surface for a curved approach path and not something I have tried before in ArcGIS Aviation. I have outlined the description of the flight OIS below and just want to understand the workflow of using a customizeOIS.exe to create this. Have been working through Creating curved approach obstruction identification surfaces—ArcMap | Documentation (arcgis.com) but still not sure on the workflow. Example: Description of Curved OIS (see picture attached) Curved Approach (Figure 3 path 6b) - shown in image attached as pink shading at southern end of runway The curved approach surface from the south commences at the inner edge and rises at a gradient of 2.5% (1:40) over a horizontal distance of 9,109m, extending to the edge of the lake shore. The surface edges diverge from each end of the inner edge at a rate of 10% (1:10) to a final width of 1,972m. The surface centreline follows the extended runway centreline to a point 1,318m from the inner edge. At this point the surface centreline commences a right turn of radius 2,480m through an arc of 180 degrees. Thanks in advance for any help.
... View more