Remove a callout or point added with the "Go to XY" tool

[ThomasCaruso]

Hi folks. This is a really basic question, I know, but I can't for the life of me figure it out. I accidentally added a callout with the go to XY tool and cannot remove it. I have searched all over online and in the ArcGIS help page and haven't found anything. Anyone know how to do this?

Thanks in advance,

Tom

[TimWitt2 · Accepted solution]

Thomas,

Those are added to the map as a graphic, you should be able to select them with the select elements arrow and delete them.

Tim

[ThomasCaruso]

Many thanks - this was really bugging me. Cheers!

[TimWitt2]

No problem! I had the same issue once and it was really annoying!

[WhitneyMarshall]

Where do I fin the select elements arrow

[Bud]

I noticed that the pins are a bit buggy. They become misaligned when you pan around in the map.

The issue is especially obvious when I use the Select All tool in the Graphics bar in the ribbon. When I select the pins (graphics), the bounding boxes/selections are misaligned with the pins. So that confirms that the pins have alignment issues.

Has anyone else noticed that issue?